Welcome to the new location of Alien's Wiki, sharing a single dokuwiki install with the SlackDocs Wiki.

Welcome to Eric Hameleers (Alien BOB)'s Wiki pages.

Differences

This shows you the differences between two versions of the page.

--- wiki:talk:slackware:madwifi [2007/12/31 11:57] – Answer a question about '600' filemode 80.56.230.164
+++ wiki:talk:slackware:madwifi [2008/09/11 00:58] (current) – 71.49.35.95
@@ Line 11: / Line 11: @@
 Hi! Pity you don't give any other info. With a mode 600 for the configuration file, wpa_supplicant works perfectly on a lot of other computers. You should check what you are doing out of the ordinary. Do you try to run wpa_supplicant as non-root? The permission is set to prevent non-root users from 'stealing' the PSK. \\
 --- Eric
+as far as i can tell, i'm not doing anything out of the ordinary.  wpa_supplicant is run at boot time.  i haven't made any modifications to the rc.inet1 or rc.wireless scripts.  i've only edited (as root) my wpa_supplicant.conf file to include my home essid and psk.  chmodding it 600 prevented me from getting on my network, presumably because the file was not being read.  reversing the chmod corrected the problem.
+//__September 9th 2008__//
+Using the trunk madwifi drivers with 2.6.26 kernel and wpa_supplicant 0.6.4, I have to use 'wpakey'.  It's a program shipped with madwifi.
+wpakey -i ath0 -w
+This enables wpa and allows wpa_supplicant to authenticate with my access point.
+Shane

Trace: